Bump N Grind vs. Mini-Lotus Texture Comparison

Description

First you'll enter past the three rows of alternating speed bumps and ribs, then on to the grinding action of the vortex, another set of bumps, and then vortex again, and if you're still going, you've got one more soft set of larger bumps that will softly welcome you home with a nice hug.

Characteristics

The canal texture starts with a 0.8 x 0.6 inch (20 x 15 mm) smooth walled chamber, which has a ring of flat hemispheric bumps at the end. The shape and size of the bumps is comparable to those of the Speed Bump Insert. Next is a 0.4 x 0.6 inch (10 x 15 mm) chamber containing another ring of hemispheric bumps. This is followed by a third 2.35 x 0.7 inch (40 x 18 mm) chamber that has a ring of hemispheric bumps at the chamber entrance as well as the exit with a zigzag-shaped ridge texture in the center. Experienced Fleshlight users will be familiar with this ridge texture because it has been partially borrowed from the Vortex Insert. The fourth chamber has the same structure as the preceding chamber except for some additional bumps at the end.

Other

Description

The Mini-Lotus features all the realistic vaginal sensations of the original Lotus texture, but moved closer to the orifice allowing every man to experience all this sleeve has to offer.

Characteristics

The Mini-Lotus inner canal is an advancement of the classic Lotus texture, with the Lotus node located approximately 0.78 inches (2 cm) nearer to the front. The Mini-Lotus insert has been especially designed for men with a shorter penis length (4 inches and less) who are unable to reach the Lotus chamber of the classic Lotus insert or only able to reach a part of it.

The structure of the Mini-Lotus canal is very similar to that of the Lotus canal. A new feature is an additional small chamber at the canal entrance with tight 0.4 inch entry and exit points. This is followed by, as in the classic Lotus insert, a large pre-chamber, the convex-concave Lotus node and a second large chamber. The large chambers measure 0.6 x 0.6 inch (15 x 15 mm) and thus are a bit smaller than those in the classic Lotus canal. Next, a 0.6 inch long connection canal with a diameter of 0.4 inch leads to the chambers in the rear part of the insert. These chambers are the same size as the chambers inside the Lotus insert (0.6 x 0.8 inch) and, because of the more forwardly located Lotus node, there was enough space to add an additional fifth chamber to the Mini-Lotus canal.

Other

Because of the large number of chambers, the clean-up of the Mini-Lotus insert is quite time-consuming and you should thus briefly turn the insert inside out. Drying time is average, taking about 3-4 hours. This texture is not to be confused with the Mini-Lotus Lager, from the SIAC line.